Best Hand Clothes Wringer (Made in USA)
If you've ever hand washed laundry you know that wet clothes take way too long to dry which is why a hand wringer is so useful. A wringer can remove much more water than twisting and trying to hand wring a clothing article yourself. A time tested processes of hand cranking a wringer helps speed up the drying time of your laundry by getting more water out than you could do by hand and especially better than just letting clothes drip dry.
Our hand clothes wringer is great for getting water out of a variety of washable materials such as wringing towels, chamois as well as the family laundry. The wringer will work with thin or thicker clothing articles by adjusting the pressure on the rollers. For the difficult items such as jeans and other uneven clothes items with buttons, zippers, and snaps you'll find success but know that it's not as simple to wring water from such areas where pockets, zippers, buttons and other doubled fabric layers combine together making it tough to get those parts through the rollers. Buttons can break if the pressure is too much when going through the rollers.
Use the best hand clothes wringer at the gym, garage, car wash, motel, swimming pool, hospital and your home for clothes, chamois, towels, bathing suits, etc.
Our wringer is built tough and very durable here in the USA. It has a rust free zinc plated finish on it's all-steel frame and steel tube handle. (note roller shaft is not zinc plated and can rust.) Hard maple wood bearings that hold the rollers in place never need oil. A single, adjustable screw at the top of the wringer applies pressure evenly to a tempered steel spring over the length of the wringer roller and presses the top roller down over the bottom roller which is turned directly by the handle. The top roller turns by friction.
Attach the wringer to a stationary tub, portable tub, round wash tubs, square wash tubs or oval wash tubs. The wringer's clamps however will require some type of shim to be able to tighten against the thinner metal of a galvanized wash tub. Clamps will open as wide as 1 3/4" to be able to attach to more secure 2x4's or other sturdy locations (see pictures). (Don't over open the clamps as it might pull the e-clip through the end of the round disk on the tip of the thumb screw causing it to fall off).
The wringer's metal frame size is 15.5" wide. With the crank handle attached it extends the length to 29". The frame height is 8.5" but extends to 10.25" counting the tension screw knob on top. The metal frame is 2" deep with a 6" drip tray the slides into the frame under the rollers. The usable inside (between the frame) width is 11.25" from one side of the roller to the other. Weighs 15 lbs assembled. The best hand wringer is great for daily use and to get prepared in case the power goes out.
Note: Shipping to Alaska, Hawaii and PO boxes requires additional postage. Please contact seller for quote and shipping arrangements to avoid order being canceled. If your address is to a PO box please contact the us and give an alternate address where UPS can deliver to.
100% Made in USA